E
17
Lap time recording (fig. 10 and fig. 11)
This function lets you record lap time and displays top
speed and engine rpm during that lap.
Select TRIP indication in the display (4, fig. 10).
Press the engine start button (5, fig. 11) while riding to start
the on-board chronometer. When button (5) is pressed
again, the chronometer will stop and at the same time will
start the on-board chronometer to read the 2nd time.
It is possible to save up to a maximum of 19 laps; if you
save a higher number of laps, the first ones saved will be
lost (the “last” 19 laps are saved in the memory).
Notes
In LAP mode, the engine may not be started using
the starter button (5).
Saved lap time display function (fig. 10)
After measuring lap times, up to 19 times may be retrieved
and displayed on the LCD. After switching the bike off,
press button (2, fig. 10) and turn the key from OFF to ON
in order to access the function.
From within this function, pressing the button (1, fig. 10)
will scroll through recorded times. The instrument panel
provides the following information:
- Lap number (6);
- Top engine rpm (7, fig. 10) during selected lap;
- Lap time (4, fig. 10);
- Top speed (8, fig. 10) during that lap.
6
8
4
2
1
7
fig. 10
5
fig. 11
ProCarManuals.com
To Next Page
Loading...
