Ducati MULTISTRADA V45 - Light Control

Light control
Low / High beam
By means of  (A) it is possible to switch from
low beam to high beam and vice versa: position (B)
for high beam, position (C) for low beam. To flash,
press the  in position (D).
If engine is not   turning the key to on, it
is  possible to switch on the lights or
flash.
If within 60 seconds from the manual switching on of
the low or high beam the engine is not  the
lights are turned 
To preserve the motorcycle  the headlight is
automatically switched  when  the engine
and it is then switched on again when the engine has

DRL in "Auto" mode only for version with DRL
lights
If the DRL was set to "Auto" via the "DRL" function
within  menu (page 217), the instrument
panel automatically manages the DRL and the low
beam according to detected ambient light:
- if the instrument panel detects good light
conditions (day) the DRL is turned on and the
low beam is turned 
- if the instrument panel detects poor light
conditions (night) the DRL is turned  and the
low beam is turned on.
When the DRL is set to Auto mode, the
corresponding warning light (14, Fig 92) will turn on.
If the DRL was set to "Auto" mode, press 
(E, Fig 276) to disable that mode and set manual light
management. Press again  (E, Fig 276) to re-
D
B
C
A
E
Fig 276
273