Centre stand
Always use the centre stand (1) (if present) to safely
park the motorcycle. Its structure ensures proper
of the motorcycle even under full load.
Before lowering the centre stand, make sure
that the bearing is hard and flat.
Push with your right foot onto central stand bearing
(2), until it touches the ground; meanwhile
pull the motorcycle up and back.
To bring central stand at rest, just push motorcycle
forward, holding it at the handlebar, until the rear
wheel touches the ground. Stand will automatically
go back in place.
Before moving always make sure that the
central stand is at its rest position.
Check for proper operation of the stand mechanism
(two springs, one into the other) at regular intervals.
Fig 25
Fig 26
47
To Next Page
Loading...
