- 50 -
DRUM LOCK
Drum does not rotate. Turn off the power and
contact your service person.
CUTTER LOCK
Master cutter does not operate. Turn off the
power and contact your service person.
POWER(T.H)NG
Thermal head power is abnormal. Turn off the
power, wait for a few seconds, and then turn on
the power again. If this indication appears again,
turn off the power and contact your service
person.
ONLINE ERROR
Communication error occurred during on-line
platemaking. Check the connection cord and
retry. Turn off the power, wait for a few seconds,
and then turn on the power again. If this
indication appears again, turn off the power and
contact your service person.
To Next Page
Loading...
