Duplo RTM-08 - Programming a JOB on the Control Panel

Chapter
2
Programming a JOB on the Control Panel
2
This chapter describes how to program a JOB on the control panel of the
DC-618.
Programming a JOB on the Control Panel
Before Programming a JOB
...............................................................
12
Standby Screen
........................................................................
12
JOB Entry
.....................................................................................
14
Setting for Processing with the RTM (Rotary Tool Module)
....................
14
Wizard
...................................................................................
18
Direct - Advanced Mode
..............................................................
34
Direct - Simple Mode
..................................................................
41
Processing Documents by Retrieving a Saved JOB
..................................
48