Duplo RTM-08 - Table of Contents

iv
Chapter 4
Chapter 3
Chapter 2
Chapter 1
Contents
Introduction
.............................................................................
i
Notes on Safety (Please Read and Observe)
...................................
ii
Before Using This Module
About the RTM (Rotary Tool Module)
.............................................
2
Appearance
......................................................................
2
Inside of the DC-618
...........................................................
4
How to Remove and Install the RTM (Rotary Tool Module)
..................
5
Removing the RTM (Rotary Tool Module)
..................................
5
Installing the RTM (Rotary Tool Module)
...................................
6
How to Replace a Rotary Tool
.....................................................
7
Removing a Rotary Tool
.......................................................
7
Attaching a Rotary Tool
........................................................
9
Adjusting the Depth of a Rotary Tool
......................................
10
Programming a JOB on the Control Panel
Before Programming a JOB
......................................................
12
Standby Screen
...............................................................
12
JOB Entry
............................................................................
14
Setting for Processing with the RTM (Rotary Tool Module)
...........
14
Wizard
..........................................................................
18
Direct - Advanced Mode
.....................................................
34
Direct - Simple Mode
.........................................................
41
Processing Documents by Retrieving a Saved JOB
.........................
48
Basic Operations
Process
..............................................................................
52
Adjust
.................................................................................
54
Programming a JOB on a Computer
PC Controller Setting
..............................................................
58
Main Menu
.....................................................................
58
Wizard
..........................................................................
62
Direct
............................................................................
80
Retrieving and Processing a Saved JOB
......................................
90
Setting Default Values for a JOB
................................................
91
Environment
...................................................................
91
Function Settings
...................................................................
93