Duplo RTM-08 - Page 25

JOB Entry
17
Programming a JOB on the Control Panel
2
In the case of
2
, you cannot set processing positions for the trail margin of 20 mm in the Y
direction of
Pattern 2
.
● Limitations
The fi gure below shows that the
unit R
and the
unit L
processing
Pattern 1
are located
above a document. (
1
s in the fi gure)
2
in the fi gure shows that the
unit R
processing
Pattern 2
is located between 5.0 to 47.9
mm from a fi nished product on the operator’s side.
When a JOB is programmed with the
unit R
at this position, the
unit L
is located outside of
a fi nished product. If the
unit L
processes
Pattern 2
, it comes into contact with the edge of
a fi nished product and may cause a document jam.
3DWWHUQ
3DWWHUQ
3DWWHUQ
3DWWHUQ
<㸦/HQJWKZLVH㸧
570SURFHVVLQJSRVLWLRQ
/
PP
PP
;&URVVZLVH
5
'RFXPHQW
IHHG
GLUHFWLRQ
5
/
1RQRSHUDWRUVVLGH
2SHUDWRUVVLGH
: A position where the
unit L
comes into
contact with the edge of a fi nished product.
REFERENCE
1
1
2