9. Adjusting the seam width
9.1 Presetting the seam width
Caution: Danger of injury!
Switchthemainswitchoff.
Adjust the seam width only with the machine switched off.
Standard
You can choose among two seam widths:
·
Seam width “Narrow” = Lever 2 mounted in position B
·
Seam width “Wide” = Lever 2 mounted in position A
The seam width “Narrow” is 2.2 mm and “Wide” 3.3 mm.
Attention: Danger of breakage!
The mechanical components of each sewing equipment are to be used
only with one
seam width, and so cannot be changed or adjusted either
in the sewing equipment configuration.
When the sewing equipment is changed, the s ewing width will
automatically match the sewing equipment.
Both sewing width - electronical and mechanical must be either both
“narrow” or both “wide”.
Under the menu «502» it is possible to c heck the value of the
electronical seam width for the sewing equipment.
When changing the configuration of the sewing equipment and the
sewing width, please make sure to have the corresponding
components of the sewing equipment mounted.
25
B2 A 1
BA 3
To Next Page
Loading...
Need help?
General
