DURKOPP ADLER 745-35-10 S - Adjusting Corner Knife

Operation
38 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
4.15.3 Adjusting corner knife
Fig. 28: Adjusting corner knife
Angle of the corner knife station
To set the angle of the corner knife station:
1. Swivel out the corner knife station ( p. 37).
2. Loosen screws (2) and (4).
3. Turn the knife blocks (1) and (3) evenly.
4. Tighten screws (2) and (4).
5. Set the angle at the other pair of knives accordingly.
6. Swivel in the corner knife station.
Height of the corner knives
The height of the corner knives cannot be adjusted. The knives always cut
through completely.
CAUTION
Risk of injury from sharp parts!
Cutting.
Adjust the corner knife station only when the
sewing unit is switched off.
(1) - Knife block
(2) - Screw
(3) - Knife block
(4) - Screw
①② ③④