DURKOPP ADLER 745-35-10 S - Working Method a (Production of Jackets)

Operation
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 63
4.20.3 Working method A (production of jackets)
Positioning points for left or right jacket front parts
Fig. 55: Positioning points for left or right jacket front parts
To position left or right jacket front parts:
1. Position the left jacket front parts at the rear positioning point (light
spot (4)).
OR
1. Position the right jacket front parts at the front positioning point (light
spot (8)).
Proper setting
When the parts are positioned at light spot (6), the distance between
breast dart (1) and flap edge (2) will always be the same.
Information
We recommend that you create a pocket program for left jacket front parts
(rear positioning point selected) and a pocket program for right jacket front
parts (front positioning point selected). This will save you the trouble of al-
tering the pocket program on the start screen when changing between left
and right jacket front parts.
(1) - Breast dart
(2) - Flap edge
(3) - Light spot
(4) - Light spot
(5) - Stop
(6) - Light spot
(7) - Stop
(8) - Light spot
①② ③④ ⑤
⑥
⑦
⑧