Operation
40 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
4.17 Performing a quick stop
To perform a quick stop:
1. Press the pedal back.
The current step of the positioning sequence or the sewing cycle is
stopped immediately.
The display shows the following message:
Error 9601
.
2. Press the pedal back again.
The carriage moves out of the loading area.
4.18 Flap and piping projection
Unhindered passage of the workpieces at the folder/pick-up folder requires
that the maximum projections of piping, flap and material thickness (see
diagram) not exceed the permissible limit. For the maximum allowable pip-
ing strip widths for the respective sewing equipment (E-No.), refer to the
Equipment Sheets of the 745-35-10.
Fig. 30: Flap and piping projection
(1) - Folder
(2) - Flap projection max. 20 mm.
(3) - Flap
(4) - Piping strip
(5) - Flap projection max. 20 mm/40 mm
(6) - Guide plate at the folder
NA: Seam projection
a, b: Material passage at the folder
To Next Page
Loading...
