DURKOPP ADLER 745-35-10 S - Page 74

Programming
72 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
5.1.5.1 Correction seam begin  p. 107
5.1.5.2 Correction seam end  p. 107
5.1.6 Marking lamps 1-16 (745-35-10 A only)  p. 109
5.1.7 Sewing head parameters  p. 110
5.1.7.1 Sewing speed  p. 110
5.1.7.2 Set soft start parameters  p. 111
5.1.7.3 Continuous or intermittent transport  p. 110
5.1.7.5 Seam securement  p. 112
5.1.8 Middle knife parameters  p. 113
5.1.8.1 Middle knife On/Off  p. 113
5.1.8.2 Speed middle knife  p. 113
5.1.8.3 Set middle knife correction seam begin.  p. 113
5.1.8.4 Set middle knife correction seam end  p. 113
5.1.9 Corner knife (straight pocket)  p. 115
5.1.9.1 Corner knife (slanted pocket) (745-35-10 A only)  p. 117
5.1.10 Automatic tape feeder On/Off (745-35-10 A only)  p. 120
5.1.10.2 Set length of tape at seam begin (745-35-10 A only)  p. 120
5.1.10.3 Set length of tape at seam end (745-35-10 A only)  p. 120
5.1.11 Transport clamp  p. 121
5.1.11.1 Set return speed  p. 121
5.1.11.2 Set insertion speed  p. 121
5.1.11.4 Return of transport clamp  p. 122
5.1.11.5 Waiting position of transport clamp  p. 123
5.1.12 Process of transport clamp  p. 126
5.1.12.1 Select transport clamp quick adjustment
(745-35-10 A only)
 p. 125
5.1.12.2 Select process of transport clamp  p. 126
5.1.13 Program loading process  p. 127
5.1.13.1 Select flap clamps  p. 127
5.1.13.2 Vacuum On/Off  p. 127
5.1.13.3 Downholder On/Off  p. 127
5.1.13.4 Select downholder mode (745-35-10 A only)  p. 128
5.1.13.5 Set blowing mode (745-35-10 A only)  p. 130
Menu item
Option/described
on page