DynaGen GSC400 Series - 3 Sender Table Configuration Utility

23 of 44
User Manual for the GSC400 Programmer and PC Interface
3 Sender Table Configuration Utility
The GSC400 contains preloaded sender tables from the factory. If you are using
a sender that is not supported by default the Sender Table Configuration Utility
(will be called the Utility from now on) may contain the table for your sender
which you can load to the GSC400. You can also create your own table using
the Utility and load it to the controller. The controller can store up to three sender
tables for each analog sender type.