DynaGen GSC400 Series User Manual

5 of 44
User Manual for the GSC400 Programmer and PC Interface
1 PC Interface Setup
1.1 Before you begin
In order to install and use the DynaGen software, you should have a basic
understanding of how to use your computer. If you do not, we recommend that
you ask someone who does to help you, or that you read the user manual that
came with your computer.
If you encounter any problems or errors while installing the DynaGen
Configurator software, please refer to Troubleshooting Guidelines on page 38.
1.2 Software / Hardware Requirements
For the DynaGen Configurator software to work reliably and efficiently, your
computer must meet or exceed the minimum requirements specified in the
following table.
The GSC400 programming connector is meant only for programming or short
duration monitoring. Do not leave pluged in for more than a few hours when the
generator is running.
Operating System
Windows XP, Vista, 7, 8,
8.1
Processor
Pentium 3 or higher
Memory
Minimum 256 MB RAM
Hard Drive
Minimum 30 MB Free
Disk Space
Video card display
Minimum 256 colors at
1024x768
Peripherals
CD-ROM Drive
Port
USB or RS232
1.3 Installing the GSC400 PC Interface
This section will guide you through the PC Interface install process.
1. Ensure that the GSC400 Programmer USB cable is not plugged into
the computer.

DynaGen GSC400 Series Specifications

General

Brand	DynaGen
Model	GSC400 Series
Category	Controller
Language	English