DynaGen GSC400 Series User Manual

12 of 44
User Manual for the GSC400 Programmer and PC Interface
1.5 Determining the USB COM Port
If you opted to use the USB cable and install the USB drivers, a COM port will be
reserved whenever the GSC400 Programmer is plugged into the computer with
the GSC400 controller powered.
This section will help you determine the COM port. The GSC400 programmer
has to be plugged into the computer and into the GSC400, and the GSC400
has to be powered.
1.5.1 Windows XP
a. Click the Start Menu icon – located in the lower
left hand corner of the desktop – and right click
on “My Computer”. A menu will come up as
shown. Click on “Properties” at the very bottom.
b. A “System Properties” window will pop up as
shown. Click the “Hardware” tab.
Figure 16 – XP Start Menu.
Figure 17 – XP System
Properties Window

DynaGen GSC400 Series Specifications

General

Brand	DynaGen
Model	GSC400 Series
Category	Controller
Language	English