DynaGen GSC400 Series - Installing the USB Drivers Manually

39 of 44
User Manual for the GSC400 Programmer and PC Interface
5.3.1 Installing the USB Drivers Manually
The USB drivers for the GSC400 programmer are installed at the same time as
the PC Interface. If for some reason when you plug in the GSC400 programmer
(with the GSC400 powered) and Windows does not detect the GSC400
programmer then follow these steps:
1. When you plug in the GSC400
programmer windows should pop up a
dialog box shown to the right. If it does
not refer to section 5.3.2 below to get this
window to appear.
Select the option “No, not this time.” and
click next.
2. The window to the right will appear.
Select the second option, “Install from a
list or specific location,” and click Next.
Figure 54
Figure 55