EasyManuals Logo

DynaGen GSC400 Series User Manual

DynaGen GSC400 Series
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
29 of 44
User Manual for the GSC400 Programmer and PC Interface
example the range of a temperature sender may extend down to 30
0
F but
when connected to a wrong impedance input it may be limited to 40
0
F.
To do this in the Sender display area right click on the sender in the table
you want to convert and select “Copy Final Table to Editor”. The table will
be copied to the “Create Sender Table” section. Enter a Name, Sender
Name, and units (use same units as existing table), and finally select the
impedance you wish to use. Then click the “Build Sender Table” button.
The new sender table will now appear in the list of sender tables to the
right with the desired impedance.
3. The controller hardware revision must be determined. If you have an
older controller it will be revision A (denoted by an LS or LX in the serial
number on the back of the controller), while all newer controllers are
revision B (denoted by an LSB or LXB) or higher.
You need to set the hardware version by going to the Settings>Controller
Hardware Version at the top of the GSC400 PC Interface.
Additional Info for Advanced Users
Table 2 is list the impedance and gain for each of the analog inputs for the
two hardware revisions.
Table 2 Analog Input Specifications
Analog Input Pin
Impedance
Gain
2 (B, C revision)
Low
1
2 (A revision)
High
3
3, 4
Low
3
5, 7
High
3
6 (B, C revision)
High
1
6 (A revision)
High
3
4. Digital Senders. Analog Input pin 6 is the only pin that is compatible with
digital senders.

Other manuals for DynaGen GSC400 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DynaGen GSC400 Series and is the answer not in the manual?

DynaGen GSC400 Series Specifications

General IconGeneral
BrandDynaGen
ModelGSC400 Series
CategoryController
LanguageEnglish

Related product manuals