EA Technology UltraTEV Plus2 User Manual

EA Technology UltraTEV Plus
2
Operating Manual 2388L015
Page 53 of 66
8.3.4 Ultrasonic Measurement using the Contact Probe Accessory
The Ultrasonic Contact Probe is provided to enable discharges to be detected in enclosed
areas where there is no direct air path from the discharge source to the sensor. The Probe
connects to the external sensor connector and is clamped on to the area of interest using
the magnets surrounding the sensor plate. To avoid damage to the socket or connector
ensure that the red dots are lined up before attempting to plug in the Ultrasonic Contact
Probe. The probe will detect discharge sources inside the enclosed area by detecting the
energy transmitted to the enclosure. Care must be taken to eliminate other sources that
could cause the signals from discharges to be masked, e.g. accidental movement of the
probe itself or strong vibration on the panel.

EA Technology UltraTEV Plus2 Specifications

General

Brand	EA Technology
Model	UltraTEV Plus2
Category	Measuring Instruments
Language	English