Eaton 9355 - Page 51

Eaton 9355 UPS (10/15 kVA) User’s Guide 164201594—Rev H0 39
Figure 21. UPS Rear View (3-High Shown)
Battery Circuit Breaker
UPS Wiring
Access Cover
Conduit Landing Plates
6. For UPS only installations, proceed to Step 7; for UPS installations with an input isolation transformer,
proceed to Step 10.
7. Remove the UPS wiring access cover and one of the conduit landing plates and retain (see Figure 21).
8. Punch two holes in the conduit landing plate for the input and output conduit using a Greenlee
®
punch or
similar device.
9. Proceed to Step 12.
10. Verify that the input circuit breaker is in the OFF position (see Figure 22).
11. Remove the input isolation transformer wiring access cover and retain.
UPS System Installation