133 Eaton® 9390 (100–160 kVA) UPS Installation and Operation Manual 164201604—Rev F
1122..22 LLaannSSaaffee PPoowweerr MMaannaaggeemmeenntt SSooffttwwaarree
Each Eaton 9390 UPS ships with LanSafe Power Management Software. To begin installing LanSafe software,
see the instructions accompanying the Software Suite CD.
LanSafe software uses an RS-232 serial link to communicate with the UPS. The software provides up-to-date
graphics of UPS power and system data and power flow, a complete record of critical power events, and
notification of important UPS or power information. With custom views for monitoring status and metering
information, various user groups can select the most useful view for their specific needs.
1122..33 RReemmoottee NNoottiiffiiccaattiioonn
For connection and setup of a modem, or to enable Remote Notify and Call Home features within the UPS,
please contact Eaton (see 1.7 Getting Help).
Remote Notification provides the UPS with the capability to use a standard off-the-shelf PC modem as a
telephone interface. The features provided by this option are:
• Call a remote terminal or pager based on programmable events and alarms
• Four separate, programmable notification groups (phone numbers)
• Automatic answering (user-configurable) for access to the Terminal mode of the UPS
• Remote and local ability to clear Call Out alarms and events
• Error detection and correction for misconfigured and disconnected modems.
Remote Notification provides the user with the option of receiving alarms and notices at a remote location.
Using the Terminal mode, the user calls the UPS to perform basic monitoring. In the event of a UPS alarm or
notice, the user is notified at the remote location. The UPS calls through the modem to the user's computer or
pager and leaves a message.
Remote Notification is an extension of the Terminal mode with the additional support algorithms necessary to
control an external modem. Connection to the UPS is made when a user calls the UPS on the phone. The user
has exactly the same capabilities as if using a terminal connected directly to an RS-232 port.
Communication
To Next Page
Loading...
