Eaton 9390 - Enter Password

Eaton® 9390 (100–160 kVA) UPS Installation and Operation Manual 164201604—Rev F 84
88..22..88 SSyysstteemm SSeettuupp LLeevveell 00 SSccrreeeennss
Press the SSEETTUUPP pushbutton on the main menu bar to display the System Setup Level 0 Screen. This screen
can be used to:
• Enter a password to access Level 1 functions (see 8.2.9 System Setup Level 1 Screens)
No password is necessary to access Level 0 functions.
• Set the screen contrast
• Show the firmware versions installed
• Identify the UPS type
Figure 54 shows the System Setup Level 0 menu screen.
Use the
USING THE CONTROL PANEL
Eaton 9390 UPS (20–80 kVA) and 9390IT (20-40 kVA) Installation and Operation Manual S 164201603 Rev 4
8-4
8.2.2 Event Screens
Press the EVENTS pushbutton on the main menu bar or History Menu bar to display a
listing of all system events that are currently active. The most recent event is listed
first. As events clear, they are removed from the Active System Events listing.
Figure 8‐4 shows the Active Events screen.
To scroll through the events, press the
or pushbuttons on the menu bar.
ACTIVE EVENTS
HISTORY
ALARM: INPUT AC UNDERVOLTAGE
ALARM: BYPASS AC UNDER VOLTAGE
NOTICE: BATTERY VOLTAGE LOW
NOTICE: NO SYNC ON
NOTICE: BYPASS NOT AVAILABLE
NOTICE: CONFIGURATION ERROR
Figure 8‐4. Active Events Screen
or
USING THE CONTROL PANEL
Eaton 9390 UPS (20–80 kVA) and 9390IT (20-40 kVA) Installation and Operation Manual S 164201603 Rev 4
8-4
8.2.2 Event Screens
Press the EVENTS pushbutton on the main menu bar or History Menu bar to display a
listing of all system events that are currently active. The most recent event is listed
first. As events clear, they are removed from the Active System Events listing.
Figure 8‐4 shows the Active Events screen.
To scroll through the events, press the
or pushbuttons on the menu bar.
ACTIVE EVENTS
HISTORY
ALARM: INPUT AC UNDERVOLTAGE
ALARM: BYPASS AC UNDER VOLTAGE
NOTICE: BATTERY VOLTAGE LOW
NOTICE: NO SYNC ON
NOTICE: BYPASS NOT AVAILABLE
NOTICE: CONFIGURATION ERROR
Figure 8‐4. Active Events Screen
pushbuttons to highlight the setup function screen desired, then press the SSEELLEECCTT
pushbutton to display the function screen.
FFiigguurree 5544.. SSyysstteemm SSeettuupp LLeevveell 00 SSccrreeeenn
ENTER PASSWORD
CONTRAST ADJUST
VERSIONS
UNIT TYPE
SYSTEM SETUP LEVEL 0
SELECT
Using the Control Panel
For Internal Use Only