Eaton® 9390 (100–160 kVA) UPS Installation and Operation Manual 164201604—Rev F 12
For external wiring requirements, including the minimum AWG size of external wiring, see Table E through
Table G of Figure 83. The power wiring connections for this equipment are rated at 90°C. If wire is run in an
ambient temperature greater than 30°C, higher temperature wire and/or larger size wire may be necessary
Control wiring for Emergency Power-off (EPO) and optional accessories (such as building alarms and
monitoring interface) should be connected at the customer interface terminal blocks located inside the UPS.
LAN and telephone drops, for use with X-Slot connectivity cards, must be supplied by facility planners or the
customer.
33..33 IInnssppeeccttiinngg aanndd UUnnppaacckkiinngg tthhee UUPPSS CCaabbiinneett
The cabinet is shipped bolted to a wooden pallet and protected with outer protective packaging material (see
Figure 2).
FFiigguurree 22.. EEaattoonn 99339900 UUPPSS ((110000––116600 kkVVAA)) CCaabbiinneett aass SShhiippppeedd oonn PPaalllleett
UPS Installation Plan and Unpacking
To Next Page
Loading...
