6. Function blocks
6.1 Manufacturer function blocks
Parameter set
Configuration/time range Description Note
Function block release by EN
is necessary
If this checkbox is enabled, the
state of function block input EN
will be evaluated. If the checkbox
is disabled instead, the function
block will be enabled and function
block input EN will not do any-
thing.
This parameter ensures that
when existing programs are
copied, the functionality of the
function blocks that are car-
ried over will be retained. The
parameter will be auto-
matically set to 0 or 1 depend-
ing on the function block.
Parameter display
+ Call enabled
Function block parameters and con-
stants can be edited on the device.
Simulation possible
Other
Retention
The function block does not recognize retentive data.
See also
→ Section "HW - Weekly timer (Hour Week)", page 168
→ Section "HY - Year time switch (Hora Year)", page 178
→ Section "RC - Real-time clock", page 192
→ Section "T - Timing relay", page 195
→ Section "WT - Weekly timer (WeekTable)", page 215
→ Section "YT - Year time switch (Year Table)", page 209
easyE4 11/18 MN050009 EN www.eaton.com
191
To Next Page
Loading...
Need help?
General