6. Function blocks
6.1 Manufacturer function blocks
Parameter set
Description Note
Function block release by
EN is necessary
If this checkbox is enabled, the state
of function block input EN will be
evaluated. If the checkbox is dis-
abled instead, the function block will
be enabled and function block input
EN will not do anything.
This parameter ensures that
when existing programs are
copied, the functionality of the
function blocks that are carried
over will be retained. The para-
meter will be automatically set
to 0 or 1 depending on the func-
tion block.
Parameter display
+ Call enabled
Function block parameters and con-
stants can be edited on the device.
Simulation not possible
Other
Retention
The function block does not recognize retentive data.
User example
The trigger pulse is set at 03:32:21 (hh:mm:ss). The other stations are synchronized at
03:33:00. The time is accepted by all stations.
See also
→ Section "GT - Get values from NET", page 339
→ Section "PT - Put values to NET", page 342
→ Section "Setting up a NET", page 537
348
easyE4 11/18 MN050009 EN www.eaton.com
To Next Page
Loading...
Need help?
General