EDR-5000 IM02602007E
Name Description
IEC61850.VirtOut18-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut19-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut20-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut21-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut22-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut23-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut24-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut25-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut26-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut27-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut28-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut29-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut30-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut31-I Module input state: Binary state of the Virtual Output (GGIO)
IEC61850.VirtOut32-I Module input state: Binary state of the Virtual Output (GGIO)
Profibus.Data OK Data within the input field are OK (Yes=1)
Profibus.SubModul Err Assignable Signal, Failure in Sub-Module, Communication Failure.
Profibus.Connection active Connection active
Profibus.Comm Cmd 1 Communication Command
Profibus.Comm Cmd 2 Communication Command
Profibus.Comm Cmd 3 Communication Command
Profibus.Comm Cmd 4 Communication Command
Profibus.Comm Cmd 5 Communication Command
Profibus.Comm Cmd 6 Communication Command
Profibus.Comm Cmd 7 Communication Command
Profibus.Comm Cmd 8 Communication Command
Profibus.Comm Cmd 9 Communication Command
Profibus.Comm Cmd 10 Communication Command
Profibus.Comm Cmd 11 Communication Command
Profibus.Comm Cmd 12 Communication Command
Profibus.Comm Cmd 13 Communication Command
Profibus.Comm Cmd 14 Communication Command
Profibus.Comm Cmd 15 Communication Command
Profibus.Comm Cmd 16 Communication Command
IRIG-B.IRIG-B active Signal: If there is no valid IRIG-B signal for 60 sec, IRIG-B is regarded as inactive.
IRIG-B.High-Low Invert Signal: The High and Low signals of the IRIG-B are inverted. This does NOT mean that the wiring is faulty. If
the wiring is faulty no IRIG-B signal will be detected.
www.eaton.com 1006
To Next Page
Loading...
