EDR-5000 IM02602007E
Parameter Description Setting range Default Menu path
AppLink num retries The number of times the device will retransmit an
Application Layer fragment
0 - 255 0 [Device Para
/DNP
/Communication]
Unsol Reporting Enables supports unsolicited reporting. This is only for
Network connections available. For serial connection this
setting is fix set to inactive
Inactive,
Active
Inactive [Device Para
/DNP
/Communication]
Unsol Reporting
Timeout
Set the amount of time that the outstation will wait for an
Application Layer confirmation back from the master
indicating that the master received the unsolicited
response message.
1.0 - 60.0s 10s [Device Para
/DNP
/Communication]
Unsol Reporting
Retry
Set the number of retries that an outstation transmits in
each unsolicited response series if it does not receive
confirmation back from the master.
0 - 255 2 [Device Para
/DNP
/Communication]
TestSeqNo Test if sequence number of request is incremented. If it is
not correctly incremented the request will be ignored. It is
recommended to have it inactive but some older DNP
implementations need it activated.
Inactive,
Active
Inactive [Device Para
/DNP
/Communication]
TestSBO It enables a stricter comparing of SBO and operate
command. For older DNP versions it is recommanded to
deactivated it.
Inactive,
Active
Active [Device Para
/DNP
/Communication]
Timeout SBO DNP Outputs can be controlled in a two stage procedure
(SBO: Select Before Operate). These outputs are to be
selected first by a select command. After this the bit is
reserved for this operate request. When this timer is
expired, the bit will be released.
1.0 - 60.0s 30s [Device Para
/DNP
/Communication]
ColdRestart Enables support for Cold Restart function. Inactive,
Active
Inactive [Device Para
/DNP
/Communication]
Deadb integr time Deadband integration time. 0 - 300 1 [Device Para
/DNP
/Communication]
www.eaton.com 314
To Next Page
Loading...
