Eaton EDR-5000 - Page 74

EDR-5000 IM02602007E
Assignment of Digital Inputs
There are two options available in order to determine where a Digital Input should be assigned to.
Option 1 - Assigning a Digital Input onto one or mutliple modules.
Adding an assignment:
Within menu [Device Parameter\Digital Inputs] Digital Inputs can be assigned onto one or multiple targets.
Call up the Digital Input (Arrow right on the DI). Click on the Softkey »Parameter Setting/Wrench« . Click on
»Add« and assign a target. Assign where required additional targets.
Deleting an assignment:
Select as described above a Digital Input that should be edited at the HMI.
Call up the assignments of the Digital Input (Arrow-right on the DI) and select the assignment that should be
removed/deleted (Please note, this has to marked with the cursor). The assignment can now be deleted at the
HMI by means of the Softkey » Parameter setting« and selection of » remove« . Confirm the parameter setting
update.
www.eaton.com 74
Protection Module 2
IN
Device Para/Digital Input
Protection Module 1
IN
1 2
Option
Option