Eaton i-on16 - Page 29

i-on16 3. Setting and Unsetting
Page 23
The system sets.


How Do I Know The System Is Set?
When the system sets the keypad
briefly shows:


followed by:
(The keypad may show the name of the
installer instead.)


One of four LEDs glows to show which
part of the system is set.
Note: The installer may have disabled
the LEDs to ensure that the
alarm system meets the
appropriate standards.
In addition, the installer may have
programmed the system to briefly flash
the strobe light on the external sounder
when the system sets.
Changing Your Mind
If you want to stop setting then
press (unset key).