Eaton i-on16 - Access Code

i-on16 4. Administration
Page 37
13. Press  to assign the user type to
the user.
The keypad gives a double “beep”
confirmation tone.


Access Code
No user can change any other user’s access code. (A Master User can
create an access code for a new user when they first add the user to the
system, see page 45.) Any user, except a Guard or Set Only user, can
change their own code as follows:
1. Make sure the display shows the
standby screen.


2. Press .


3. Key in your access code (or
present a tag).


4. Press  .


If you are a Master User:
5. Press .


a) Press .


b) Press .


c) Press  or . until the bottom
line of the display shows your own
user name.


d) Press .


e) Press  or . until the bottom
line of the display shows:


f) Go on to step 6.
If you are a Normal User: