Eaton i-on16 User Manual

4. Administration i-on16
Page 70
8. Press .


9. EITHER
Press the button on the remote
control that you wish to program.
Hold the button down until you
see the transmit LED flash.
Note: You cannot reprogram the unset
key on an i-fb01 remote
control.
Only the “*” button (Part set) is
available on a FOB-2W-4B.
The keypad gives a double
“beep” confirmation tone. The
display shows the identity and
owner of the remote control, and
the button you pressed. Go on to
step 10.


OR (if you do not have the remote in
your possession)
a) Press .
The display presents a list of the
registered remote controls and
their users.


b) Press  or  to show the
remote control you want to edit.


c) Press  to select it.
The display shows the first button
on the remote control.


d) Press  or  to show the button
you wish to re-program.


e) Press  to select the button.
The bottom line shows:
Note: You cannot reprogram the unset
key on an i-fb01 remote
control.
Only the “*” button (Part set) is
available on a FOB-2W-4B.



Eaton i-on16 Specifications

General

Brand	Eaton
Model	i-on16
Category	Security System
Language	English