Eaton Managed ePDU - Page 26

INSTALLATION AND CONFIGURATION
EATON Managed ePDUt User’s Guide S 164201xxx Rev 1 DRAFT 10−OCT−2008
16
10. All the configuration parameters have now been entered. All the prompts are still
displayed, so you can check the information you entered. Do one of the
following:
S If the information is correct, type y and press Enter. The system completes the
configuration and displays a message when the configuration is done.
S If one or more parameters are not correct, type n and press Enter. You are
returned to the IP configuration prompt shown in Figure 13 on page 14 and
given the opportunity to correct each piece of information. When the
information is correct, type y and press Enter to complete the configuration
and return to the opening prompt shown in Figure 12 on page 13.
S If you want to terminate the configuration process, type c and press Enter. The
configuration is cancelled and you are returned to the opening prompt shown
in Figure 12 on page 13.
11. If you entered y to confirm the configuration, a message is displayed telling you
when the configuration is complete (see Figure 18). You are then returned to the
opening prompt shown in Figure 12 on page 13. You are now ready to begin
using your ePDU.
Figure 18. Configuration Complete
NOTE The configured IP address takes about 15 seconds to take effect for the device connected through
the serial line, or even longer if configured over DHCP.