USING THE WEB INTERFACE
EATON Managed ePDUt User’s Guide S 164201xxx Rev 1 DRAFT 10−OCT−2008
58
Setting Outlet Thresholds
To set the current thresholds of an outlet:
1. Select Power Outlets, and then select Outlet Setup. The Outlet Setup page displays
(see Figure 53).
2. Select an outlet from the Show setup of outlet list.
3. Type a number in the Power off period during outlet power cycling field. When an
outlet is power cycled, it is turned off and then back on. The number you enter
here determines the length of time (in seconds) it takes for the outlet to turn
back on after is shut down during the power cycle. If left blank, this outlet will
use the value set in the Unit Setup page as a default.
NOTE You can power cycle an outlet from the Outlet Details page. See Power Cycling an Outlet" below
for instructions.
4. Set the RMS current thresholds for the outlet in the Thresholds panel.
5. Click Apply to save your changes.
Viewing Outlet Details
To display details about a particular outlet:
1. Select Power Outlet and then select Outlet Details. The Outlet Details page
displays (see Figure 54).
Figure 54. Outlet Details Page