USING THE WEB INTERFACE
EATON Managed ePDUt User’s Guide S 164201xxx Rev 1 DRAFT 10−OCT−2008
72
Configuring SMTP Logging
To configure Simple Mail Transfer Protocol (SMTP) logging:
1. Select Device Settings, and then select Event Log. The Event Log Settings page
displays. The SMTP Logging panel controls SMTP logging (see Figure 68).
Figure 68. SMTP Logging Panel
2. Select the SMTP Logging Enabled check box.
3. Type the receiver’s email address in the Receiver Email Address field.
4. By default, when SMTP logging is enabled, seven event types display in the
Event Log Assignments panel to the right. All are disabled by default. To enable any
of these event types, select the appropriate check boxes. See Figure 69.
Figure 69. Event Log Assignments Panel
5. Click Apply. SMTP Logging is configured.
NOTE If you have not configured the ePDU SMTP settings, you must do so for SMTP logging to work. Click
the here link at the bottom of the panel. See Configuring the SMTP Settings" on page 80 for instructions.