Eaton PowerXL DM1 Series - Step 5 - Standard application; Introduction

21
Chapter 4—Mechanical installation
POWERXL SERIES VFDS MN040060EN—September 2020 www.eaton.com
Mounting instruction for option cards
Step 1.
For enclosed type:
Remove the front cover (1) from NEMA 1 kit then remove
the terminal cover (2) from drive.
For open type:
Only remove the terminal cover.
Step 2.
Remove the option card port label and four snap covers from
the drive.
Step 3.
Connect the cable to option card connector (3) and MCU
board connector (4).
2
1
Enclosed type
Open type
3
4