Eaton PowerXL DM1 Series - Installation Steps for DM1 FR1 NEMA 1 Kit

24
Chapter 4—Mechanical installation
POWERXL SERIES VFDS MN040060EN—September 2020 www.eaton.com
Installation steps for DM1 FR1 NEMA 1 kit
Step 1
Insert the two hooks on thinner end of fan cover into the
two slots on top surface of drive first (refer to detail A), then
push the two hooks on thicker end of fan cover into the
two slots on top surface of drive. The thicker end of the fan
cover should face the front surface of drive.
Step 2
Remove the two screws ③, NEMA 1 kit front cover ①, and
terminal cover ② (See A).
Remove the two screws ④, NEMA 1 kit left cover ⑤, and
NEMA 1 kit right plate ⑥ (See B).
Detail A
Detail A
Thicker end
Thinner end
A
NEMA 1 kit front cover ①
2
B
NEMA1 kit left plate ⑤
NEMA1 kit right plate ⑥
Terminal cover
②
Screws ③
Screws ④