Eaton PowerXL DM1 Series - Installation Steps for DM1 FR2-FR4 NEMA 1 Kits

26
Chapter 4—Mechanical installation
POWERXL SERIES VFDS MN040060EN—September 2020 www.eaton.com
Step 5
Mount the NEMA 1 kit left plate ⑤ and right plate ⑥ back to
the NEMA 1 kit main frame ⑦ and drive with screws ④ and
⑯. Then connect the input grounding wire ⑪ and output
grounding wire ⑬ to the grounding holes on NEMA 1 kit left
plate ⑤ and NEMA 1 kit right plate ⑥ (See A).
Mount the terminal cover ② back to the drive. Mount
NEMA 1 kit front cover ① back to the conduit box with
screws ③ (See B).
Installation steps for DM1 FR2-FR4 NEMA 1 kits
Step 1
Align the four hooks on fan cover with the four slots around
the fan venting holes on top surface of drive. Push the snap
joints into slots. The thicker end of fan cover should face the
front surface of the drive.
A
B
NEMA1 kit front cover ①
Terminal cover ②
Output grounding wire ⑬
NEMA1 kit left plate ⑤
NEMA1 kit right plate ⑥
Input grounding wire ⑪
Screws ⑯
Screws ④
NEMA1 kit main frame ⑦
Screws ③
Input grounding hole
Output grounding hole
Thicker end
Thinner end