Eaton PowerXL DM1 Series - P12.3 - Modbus TCP (DM1 PRO only)

46
Appendix A—Technical data and specifications
POWERXL SERIES VFDS MN040060EN—September 2020 www.eaton.com
Appendix A—Technical data and specications
Technical data
Table 27. PowerXL DM1 Series specifications (continued).
Section Description Specification
Input ratings Rated input voltage 115 V 1-phase: 100-120 Vac 1-phase
230 V 1-phase: 200-240 Vac 1-phase
230 V 3-phase: 200-240 Vac 3-phase
480 V 3-phase: 380-480 Vac 3-phase
Voltage tolerance -15%/10%
Input frequency 45 Hz to 65Hz
Input THD >120%
Connection to power Once per minute or less
Starting delay 3 s
Short-circuit withstand rating 100 kAIC (Fuses and circuit breakers)
65 kAIC (Type E CMC)
14 kAIC (Miniature breakers)
5 kAIC (All)
Power ride-thru 100 ms
Logic control ride-thru .5 s Min, 2 s typical
Total watts loss Typical efficiency 97.5% for 3-phase
Output ratings Output voltage 115 V 1 phase input: 0-2*Vin 3-phase
230 V 1 phase input: 0-Vin 3-phase
230 V 3 phase input: 0-Vin 3-phase
480 V 3 phase input: 0-Vin 3-phase
Continuous output current IL: ambient temperature maximum 40°C, up to 60°C with derating, overload
1.1 x IL (1 min/10 min)
IH: ambient temperature maximum 50°C, up to 60°C with derating, overload
1.5 x IH (1 min/10 min)
Overload current 150% of drive rating for constant torque
110% of drive rating for variable torque
Initial output current 200% (2 sec/20 sec)
Output frequency 0-400 Hz (standard)
Frequency resolution 0.01 Hz
Control characteristics Control methods Frequency control
Speed control
PM motor speed control
Performance:
V/Hz (volts per Hertz)
SVC (sensorless vector)
PM motor
±0.5% of base speed across a 30:1 speed range
±0.5% of base speed across a 60:1 speed range
±0.5% of base speed, up to a 20:1 speed range
Switching frequency 1 kHz to 16 kHz
Automatic switching frequency derating in case of overload
Frequency reference Analog input: resolution 0.1% (10-bit), accuracy +1%
Analog output: resolution 0.1% (10-bit), accuracy +1%
Panel reference: resolution 0.01 Hz
Field weakening point 20 Hz to 400 Hz
Acceleration time 0.1 s to 3000 s
Deceleration time 0.1 s to 3000 s
Braking torque DC brake: 30% x motor rated torque (Tn) (without brake chopper)
Dynamic braking (with optional brake chopper using an external brake resistor):
100% continuous maximum rating
.