Eaton SC300 - Page 100

SC300 Handbook
94
Copyright © 2007-2018 Eaton Corporation. All Rights Reserved.
IPN 997-00012-03 B2 Issue B2 July 2018
Information
The following information is available about energy metering.
Parameter Description Where to find:
Energy The total energy in kWh measured by this meter.
Energy continuously increases, except when
manually reset.
SC300: Analog Inputs >
right arrow > Energy Meter.
Down arrow to select next
energy meter if more than one.
DCTools: Meters
Web:
Applications > Energy
Metering > Meters
Current The current used in calculating this energy meter
power.
Current will show as zero if the power measurement
comes directly from a system value (e.g. solar charger
power).
Voltage The voltage used in calculating this energy meter
power.
Power The energy meter power at present. This is
calculated as Voltage * Current, except where it
is directly measured by a solar charger or other
device.
Power (Min) The minimum power since the meter started, or
the last time the power was reset.
Power (Max) The maximum power since the meter started, or
the last time the power was reset.
Meter Reset Date The last time the meter power was reset.
13:00:00 01 Jan 70 GMT+13 means that this meter
has never been reset.