System Operation
Copyright © 2007-2018 Eaton Corporation. All Rights Reserved.
IPN 997-00012-03 B2 Issue B2 July 2018
99
All Meters Log
The Meters Log is a combination of the Energy Log and Power Log. It includes all records from
both these logs.
Smart Analogues Log
The Energy Log records the values of all configured Smart Analogues at the configured Smart
Analogues Log Interval.
To log any analog input, simply configure a Smart Analog mapped to the required input.
Generator Log
This records the fuel level, fuel refill and generator state at the specified Generator Log Interval.
Fan Controller Log
This logs data from an FC100 Fan Controller logger option.
Operating Voltage Log
This logs the current working voltage of the system, including any temperature compensation
correction and the effects of Fast Charge, Equalize or Battery Test.
All Logs
This log combines all the above logs into a single file.
This log file may be large and slow to download.
If the various log intervals are different, there may be a large number of blank entries.
Raw log binary
This log is included for future use.
► To download a log using Web
Go to Logs > Download and click on Download next to the required log.
Wait for the log entries to download from the SC300.
After the download finishes, Excel gives the message “The file you are trying to open, …, is in a
different format than specified by the file extension. Verify that the file is not corrupted and is
from a trusted source before opening the file. Do you want to open the file now?”.
Click Yes.
► To download a log using DCTools
Go to Event Log, Data Log or Energy Log. Downloading will start immediately.
When downloading finishes, click on Save to File.
Type a file name, select a file type, and browse to a location to save the file.
Excel gives the message “The file you are trying to open, …, is in a different format than
specified by the file extension. Verify that the file is not corrupted and is from a trusted source
before opening the file. Do you want to open the file now?”.
Click Yes.
► To clear all logs
In Web go to Logs > Download.
In DCTools, go to Controller Log > Configuration.
Click Clear Logs.
To Next Page
Loading...
