Ebtron Advantage IV Series User Manual

TABLE 3-1 Factory Defaults, Optional Settings and Ranges
Parameter
Product
Line
Probe
Type
Special Criteria Default Optional Settings/Ranges Units
H CONFIG=RH RH
H CONFIG=ENTH ENTH
H CONFIG=DPT DPT
H CONFIG=RH % RH
H CONFIG=ENTH Btu/lb [kJ/kg]
H CONFIG=DPT F DPT [C DPT]
H CONFIG=RH 0 to 100
% RH
H CONFIG=ENTH -20 to 400 [-40 to 800] Btu/lb [kJ/kg]
H CONFIG=DPT -50 to 160 [-50 to 70]
°F [°C]
H CONFIG=RH 100 0 to 100
% RH
H CONFIG=ENTH 200 [400] -20 to 400 [-40 to 800] Btu/lb [kJ/kg]
H CONFIG=DPT 100 [50] -50 to 160 [-50 to 70]
°F [°C]
NETOUT All All BACNET MODBUS
NETOUT=BACNET 0 to 127
NETOUT=MODBUS 0 to 247
NETOUT=BACNET 76800 38400, 19200, 9600
NETOUT=MODBUS 19200 76800, 38400, 9600
PARITY All All NETOUT=MODBUS EVEN ODD, NONE1, NONE2
NETDI All All NETOUT=BACNET 2 0 to 4194302
RS485 COM All All OFF ON
DHCP All All ON OFF
IP All All 10.0.0.100 Set by network integrator
MASK All All 255.255.255.0 Set by network integrator
GATE All All 10.0.0.10 Set by network integrator
BACNET All All IP ETH
NETID All All BACNET=IP 2 0 to 4194302
UDPPORT
Advantage IV
11
All BACNET=IP 47808 0 to 65535
LONRF-LINK
RFLINK COM Advantage IV All OFF ON
USB
USB WRITE Advantage IV All ON OFF
EB-LK INTG Advantage IV -P, -T, -F 100 1 to 999 (1 to 300 for -F/An probe types) x 300 ms
EB-LK STAT Advantage IV -P, -T, -F ON OFF
ANALOG OUTPUT
EB-LINK
Advantage IV
10
All All bps
NO SETTINGS REQUIRED FOR LON NETWORK CONFIGURATION
RS-485
NETADDR All All 2
NETBAUD
ETHERNET
Note 11: UDPPORT is only applicable to GTM116e and GTM108e transmitters
Note 10: AO3 is only applicable to GTx116e transmitters that have the humidity sensor option, /H, provided with the -P probe type.
AO3 ASGN
Advantage IV
10
-P w/ RH None
AO3 UM
Advantage IV
10
-P w/ RH None
AO3 MS
Advantage IV
10
-P w/ RH 0
AO3 FS -P w/ RH
SettingsMenu_r1p Table 3-1 - Page 4

Ebtron Advantage IV Series Specifications

General

Brand	Ebtron
Model	Advantage IV Series
Category	Measuring Instruments
Language	English