Chengdu Ebyte Electronic Technology Co.,Ltd E180-Z6907A User Manual
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co., Ltd.
7-27
defaults to the end-device, channel 11(default), PAN ID random (default), transmit power is 10 (default).(The maximum
can be configured to 20)
（3）Modify node type to coordinator, and click the Enter button, the message box prompts "Configure device type
successfully". The general ZigBee 3.0 network is established by the coordinator node, so the factory default end-device
node type needs to be changed to the coordinator before establishing the network.
(4) After the node type is successfully written, modify the ZigBee network required for establishing some network
parameters (you can also use the default value without modifying the parameters). Modify the channel, network PANID
and transmit power. After modifying the parameters, click “Write Network Parameters”. ", the message box will prompt
"Write parameters successfully".
To Next Page
Loading...
