Eclipse 55090 - Page 29

29
Basic operation
t Changing the display luminance
The luminance level of the display can be changed by
the following procedure to one of three levels.
1 . Press the [FUNC] button.
2 . Press and hold the [DISP] button for more than one
second.
The luminance level will change as follows each time
the button is pressed.
3 . Press the [FUNC] button.
Function mode will then be cleared.
t Changing the spectrum analyzer's sensitivity
1 . Press the [DISP] button for more than one second
while displaying spectrum-analyzer mode.
Each press of the button changes the sensitivity of the
spectrum analyzer.
t Changing the eye contact analyzer display
The eye contact analyzer display lets you check the
state of the sound field using your eyes.
1 . Set the display mode to any mode except spectral
analyzer mode.
2 . Press and hold the [DISP] button (for 1 second or
more).
The indicator to the right of the display will change each
time the button is pressed.
The setting will change to two types of display pattern
or no display.
Hi Mid Lo
Level 1 (bright) Level 2 (standard)
Level 3 (dark)