ECOCLIM AC134HD - Page 63

EN_
810G20 - Version V5 – Juillet 2020 P. 63
Traduction de la notice originale
Input OE/CT number using keyboard if you have chosen to do so.
The key (C) allows you to correct. (20 characters max.)
To input operator trigram during the procedure, select 1.
Otherwise 0.
Input OE/CT number using keyboard if you have chosen to do so.
The key (C) allows you to correct.
Select couplers configuration (indicate which couplers are connected to
ECS).
Select 0.
To choose vacuum, select 1.
By default, vacuum duration is 20 minutes.
To modify, enter the value, and press ENTER to confirm.
By default, the leak test duration is 4 minutes.
To modify, enter the value, and press ENTER to confirm.
To program a refrigerant charge, select 1.
To modify the quantity, input the required amount and press ENTER to
confirm
Press ENTER to start the programmed cycle
Cycle sequence: Refer to chapter 9.2 Cycle sequence
ENTER
OE / CT NUMBER:
°
Register
operator trigram ?
1.Yes
0.No
ENTER
OPERATOR TRIGRAM :
°
Select couplers
1.HP
2.HP+LP
3. LP
Recovering
1. Yes
0. No
Vacuum
1. Yes
0. No
Vacuum duration
≥0 min
Tightness check
µ min
Refrigerant charge
1. Yes
0. No
Charge qty
0 g
Start process
ENTER: Yes
STOP: No