ECOCLIM AC134HD - Charge ECS after Repair

EN_
810G20 - Version V5 – Juillet 2020 P. 62
Traduction de la notice originale
To end the task after recovery, select 0.
Select 0.
Confirm by pressing ENTER to start the cycle.
Cycle sequence: Refer to chapter 9.22. Déroulement d’un cycle d’intervention
9.1.2. Charge ECS after repair
To ensure charge speed and accuracy it is unconditionally required to perform charge directly after vacuum.
After a repair that required opening of the ECS, the operator can perform the following tasks:
• Circuit vacuum with tightness check,
• Refrigerant charge.
By starting the ECS, the operator can test its performance.
From the >> ECS OPERATION << menu, select 1.
To input an aircraft type during the procedure, select 1.
Otherwise 0.
Input aircraft type using keyboard if you have chosen to do so.
The key (C) allows you to correct. (20 characters max.)
To input a serial number during the procedure, select 1.
Otherwise 0.
Input serial number using keyboard if you have chosen to do so.
The key (C) allows you to correct. (20 characters max.)
To input OE/CT number during the procedure, select 1.
Otherwise 0.
Vacuum
1. Yes
0. No
Refrigerant charge
1. Yes
0. No
Start process
ENTER: Yes
STOP: No
>> ECS OPERATION <<
1.New operation
2.Refrig transfer
Register aircraft
type ?
1.Yes
0.No
ENTER AIRCRAFT
TYPE :
°
Register
serial number?
1.Yes
0.No
ENTER
SERIAL NUMBER :
°
Register
OE/CT number?
1.Yes
0.No