11
ERASING USER INTERFACE MEMORY
IMPORTANT: Dispenser memory must be cleared when programming a new dispenser or after
upgrading User Interface software. IF USER INTERFACE IS NOT CLEARED, DISPENSER MAY
OPPERATE IRRADICALLY and REPORTS MAY BE
To enter the user interface press the ENTER key.
ENTER ACCESS CODE XXX
THEN PRESS ENTER
000
ENTER
#1 MEMORY FUNCTIONS menu.
PROMPT PRESS
1 *** DISPENSER ***
MEMORY FUNCTIONS
ENTER
CLEAR PUMP VOLUMES ?
PRESS: YES OR NO
YES
ARE YOU SURE?
PRESS YES OR NO
YES
CLEAR SUM/CYCLE REPORT ?
PRESS YES OR NO
YES
CLEAR LOAD COUNT ?
PRESS: YES OR NO
YES
CLEAR SETUP ?
PRESS YES OR NO
YES
=
ARE YOU SURE?
PRESS YES OR NO
YES
LOAD A ECO SETUP FILE ?
PRESS YES OR NO
NO
To Next Page
Loading...
