12
ENTERING DISPENSER ID AND SETUP ROUTINES
Arrow down to #2 DISPENSER SETUP ROUTINE. Press ENTER
PROMPT PRESS
CHANGE DISPENSER ID# ?
PRESS YES OR NO
YES
NEW DISPENSER ID# XX
THEN PRESS ENTER
XX
ENTER
ARROW DOWN
CHANGE MAIN ACCESS CODE ?
PRESS YES OR NO
NO
SET TIME AND DATE?
PRESS YES OR NO
YES
HOUR XX MINUTE XX
MONTH XX DAY XX YR XX
ENTER HOUR, MINUTE,
MONTH, DAY, YEAR
THEN PRESS ENTER
PRESS RESET TWO
TIMES TO RETURN TO
FORMULA SCREEN
If this is a multiple EcoJet / EcoStar 1500 installation, daisy-chain MultiLink cable to every dispenser.
The MultiLink is hard-wired to the pump board. Follow wiring instruction. (See diagram on page 11)
MAKE SURE MultiLink IS WIRED PROPERLY! DAMAGE TO PUMP BOARD AND/OR USER
INTERFACE CAN OCCUR.
All other programming is done through the EcoJet / EcoStar 1500 PC software. Programming is
covered later in this manual.
To Next Page
Loading...
