35
PROCEDURE FOR TERMINATING A FORMULA
FROM USER INTERFACE:
A FORMULA CANNOT BE TERMINATED FROM THE USER INTERFACE; IT MUST BE
TERMINATED BY THE WASH FORMULA. TO TERMINATE: LET A FORMULA RUN UNTIL IT
RECEIVES A STOP SIGNAL.
PROCEDURE FOR RESTARTING IN MID-FORMULA
FROM THE USER INTERFACE
1. Select the correct classification on the WASHER CONTROLLER.
2. Hit the RESET button the USER INTERFACE. This resets all injection occurrences back to one.
3. Start the washer.
PROCEDURE FOR ADJUSTING WASH - LOAD WEIGHT
FROM USER INTERFACE: This procedure can be used if washing NON-STANDARD load
weights. Adjusting load weight does not scale product, it is used for more accurate reporting.
1. BEFORE STARTING WASHER, enter the actual load weight in the user interface by
entering the number in the keypad.
2. Hit ENTER when done.
3. Start formula at washer
ECOJET / ECOSTAR 1500 USER INTERFACE SCREENS
AUTO FORMULA RESET!
ENTER LOAD WEIGHT XXX LB.
çç IDLE SCREEN WITH FORMULA
FORMULA TERMINATED
FORMULA 1
DATE 05/06 TIME 11:14:00
çç FORMULA RUNNING
FORMULA 1
/ PROD NAME OCCX XXX SEC
çç PUMP RUNNING
FORMULA 1
/ FLUSH XXX SEC
çç WATER FLUSHING
FLUSH ERROR !!
HIT RESET KEY TO RESUME
ççFLUSH ERROR
LOW LEVEL ALARM !!
ENTER LOAD WEIGHT XXX LB.
çç OUT OF PRODUCT
To Next Page
Loading...
