Serinus 51 User manual 1.0
Operation
27
Save parameter List
Name the file which the parameter settings will be downloaded into (at
that time), used for diagnostics
Load Configuration
Loads instrument EEPROM setting from USB key (including calibration
and communication settings, units, instrument gain etc).
Auto-Backup Interv
The Param list and config file are saved onto USB for the duration set in
this field
Load Auto-Backup Config
Loads up the last auto backup configuration (best used when
configuration has been changed in error)
-----------------------------------------------------------------------------------
Instrument
This field allows the instrument to be set to either “Online” (Normal
instrument operation) or “Offline” (data is not valid, as service work etc
is being performed). This field is used to change the instrument into
“Offline” when service work is being performed.
Next service due
An editable field where the user can set the date when the next
instrument service is required. Section 6.3 has a recommended
maintenance schedule that may be used as a basis for the interval entered
above. This value is also displayed as a non editable field in the quick
menu section 3.5.1.
Rebuild event Log Index
This feature will rebuild the logs on the USB key. This is necessary
when any changes to the files or folders on the USB key have been made
(including within a file). Rebuilding the log index will re-index all the
contents and thus allow the instrument to view error logs.
Safely remove USB stick
This feature must be activated to safely remove the USB stick (also
occurs in the quick menu 3.5.1).
System Restart
Activating this will reboot the microprocessor. This action is useful
when uploading new firmware or if tests are being carried out.
-----------------------------------------------------------------------------------
Avg conc.
Displays the SO
2
/ H2S average concentration
To Next Page
Loading...
