Serinus 51 User manual 1.0
Service
53
6
Service
6.1 Pneumatic diagram
Figure 21 Pneumatic diagram
6.2 Maintenance tools
To perform general maintenance on the Serinus 51 the user will be require the
following equipment:
• Toolbox
• Digital multimeter (DMM)
• Computer or remote data terminal and connection cable for RS232
communication
• Pressure transducer (absolute) and connection tubing, calibrated in torr
• Flow meter (1 slpm nominal)
• Minifit extraction tool
• Orifice removal tool
• 1.5mm hex key
• Assortment of 1/4” and 1/8” tubing and fittings
• Test zero air source
• Test span gas source
• Leak tester
To Next Page
