Ecotech Serinus 51 - Figure 16 Serinus Downloader - Settings Tab

Serinus 51 User manual 1.0 Calibration
49
Connection
The user must select the type of connection that the computer is connect to the
analyzer with. This is chosen in the “Connection Type” field and consists of:
Direct Serial connection:
Used when the analyzer is connected directly to PC via serial port
Port 

 Choose which port on the PC the Serinus is attached to
Baud Rate 

 Select the baud rate with which communication will
take place (must match the baud rate set on the analyzer
see the Serial Communications section)
Network Connection:
Used when the analyzer is being connected via a network.
IP Address 

 Enter the IP address of the analyzer as described in
Ecotech technote: TEC 0045
Port 

 Enter the port number of the analyzer as described in
Ecotech technote: TEC 0045
USB Connection:
Used when the analyzer is connected directly to PC via the USB connection
Analyser 

 A drop down list will display all analyzers that the
downloader program can connect to, the user must
select the appropriate analyzer number matching that of
the analyzer connected to.
Analyzer
Analyzer ID:
Enter the analyzer ID found in the “Main Gas ID” field (Main Menu 
Communications  Serial Communications)
Note: Only relevant for a direct serial
connection
Figure 17 Serinus downloader - settings tab